Home › Ask Buckets › 3D puff foam
BI
Buckets of InkSpecs from published maker data · Tempe, AZ
Short answerAdd a stop in the design after the flat embroidery, lay the 3 mm E-Zee 3D Puff Foam over the area inside the hoop, tape its edges, finish stitching, then tear away the excess foam. The design must be digitized for 3D embroidery.
Steps (Madeira)
- Cut foam large enough to cover the area to be stitched.
- When the machine stops, lay the foam over the area in the hoop and tape the edges (spray adhesive also works).
- Continue stitching.
- Tear away the excess; use tweezers for small areas.
- Poke in small remaining pieces, or shrink them with a heat gun at a low temperature to avoid burning the thread.
Foam choices
Madeira also makes E-Zee BodyBuilder Hard foam, a firm 3 mm foam for a more rigid raised effect: sharp edges with 1 piece, extra loft with 2 pieces; 11.75 x 15.75 inch sheets, 10 per pack, white and black.
Frequently asked questions
What sizes is 3D Puff Foam?
12 x 18 inch sheets, single or 10 per pack, in Forest Green.
Related: E-Zee backing chooser
Have a question for our shop? Call or text
480-229-7806 (Monday to Friday, 7:30 AM to 4:00 PM Arizona time) or
send us a message. Want to see a machine run? Visit our demo room in Tempe, AZ during the same hours. In-stock orders placed by 2:30 PM Arizona time ship the same day from Tempe, AZ. Need equipment?
Get a quote.
We Bring the Store to Your Door. ← More straight answers from our Tempe shop