Pick what is going wrong with your screen and see the fix from Ulano's technical data sheets.
What is going wrong?
Problem
What Ulano says to do
Source
Ink is still in the screen
Use All-Purpose Ink Wash, or the least powerful diluent that works: scrape off bulk ink, rub a soaked rag on both sides, rinse with water, repeat until dissolved.
All-Purpose Ink Wash (TDS)
Stencil will not come out after remover
Make sure ink and solvent residue are gone (degrease with No. 3, which speeds the remover), brush fresh remover on both sides, wait the dwell time and power wash. If the remover dried on the screen it can lock the stencil. Hardener-X treated stencils may need a high-pressure sprayer.
Brush Haze Remover Paste No. 78 on both sides with a long-bristle nylon brush, wait ten minutes (no longer), rinse gently, then power spray at very high pressure. For stubborn stains wet the screen with the ink solvent first. Industrial use; gloves and goggles.
Haze Remover Paste No. 78 TDS
CDF Vision film will not reclaim
Strong screen openers or aggressive ink washes can lock CDF Vision. Use All-Purpose Ink Wash or the ink maker's washup solvent, degrease with No. 3, then No. 4 or No. 5 and a strong spray; haze remover if needed.
CDF Vision TDS
Pinholes or stencil failure on press
Degrease the mesh as the first step of every stencil (No. 3 or Magic Mesh Prep); Ulanogel 23 also abrades the mesh to improve adhesion and press life.
Screen Degreaser No. 3 page; Ulanogel 23 TDS
Squeegee side of the stencil is soft or slimy
Ulano defines optimum exposure as a hard, not slimy, squeegee side with no positive outline visible if exposure is increased. Run a step wedge or ExpoCheck and lengthen exposure.
Ulano emulsion TDS; ExpoCheck TDS
Ink feathers in dry weather or stencil is tacky in humidity
Magic Mesh Prep adds an antistatic treatment that reduces ink whiskering in low humidity. QX-1 and CDF Vision include texturing agents Ulano says reduce humidity effects.
Magic Mesh Prep, QX-1 and CDF Vision TDS
Coating or film adhesion is uneven
Degrease and wet the mesh evenly: Magic Mesh Prep for emulsion or CDF Mesh Prep No. 25 (1-2 minutes, within an hour of adhering) for capillary film.
Magic Mesh Prep and CDF Mesh Prep No. 25 TDS
Facts from Ulano technical data sheets and product pages. Not every problem has one cause: if it persists, call 480-229-7806.
Frequently asked questions
Why won't my screen reclaim?
Common causes in Ulano's data sheets: stencil remover dried on the screen, ink or solvent residue blocking the remover, or a screen opener that locked a capillary film.
How do I remove ghosting from a screen?
Use Haze Remover Paste No. 78: brush on, wait ten minutes, rinse gently, power spray.
What should I do before stencil remover?
Remove ink with the mildest effective diluent, then degrease with Screen Degreaser Liquid No. 3.
How do I know my stencil is fully exposed?
Ulano: the squeegee side is hard and not slimy, no positive outline shows if exposure is increased, and a test print matches the positive.
Built by Buckets of Ink, Tempe, Arizona · Questions? Call 480-229-7806